weberfloor resin finish system

Surface hardness of substrate(s).

Guidance for specification option:

The surface strength of the substrate must be greater than 1 N/mm² in residential or commercial areas and 1.5 N/mm² in industrial areas.

Preparation of existing substrates.

Guidance for specification option:

The substrate should be clean and free from dust, cement, grease or other impurities which might prevent weberfloor 4716 from adhering to the substrate.

For correct film formation the substrate temperature should not fall below +6°C. For best results the temperature of the work area should be between +10 and +15°C.

Bonded or partially bonded cementitious levelling screed system.

Guidance for specification option:

weberfloor industry rapid 4655.

• Rapid drying, self-smoothing industrial screed.
• Resin receiver suitable for industrial areas.

Resin coating primers.

Guidance for specification option:

weberfloor 4716.

• Designed for priming (pre-treating) all substrates prior to application of weberfloor products.
• weberfloor 4716 should be diluted with clean water.

Resin floor coatings.

Guidance for specification option:

Consult manufacturer and insert requirements or omit.

Guidance for specification option:

Consult manufacturer and insert requirements or omit.

Guidance for specification option:

Consult manufacturer and insert requirements or omit.

Not required.

weberfloorbase rapid 4360.

Guidance for specification option:

• Optional base screed for use if the substrate cannot achieve a pull off strength test of at least 1.5 MPa.
• Rapid drying self-smoothing thick base screed.
• Pump or hand applied, self-smoothing, thick base or renovation screed for floors with Low Dust TechnologyTM, which gives a extra strong base layer for receiving tiles, thin topping screeds or industrial screeds. The product is formulated from special cements, aggregates and chemical admixtures.

weberfloor DPM.

Guidance for specification option:

• Optional moisture control system.
• Two-component epoxy based chemical damp proof membrane that is capable of being applied in one coat, dependent upon the condition of the substrate and quality of workmanship to ensure full coverage is achieved at the required thickness.