TREMproof P85
Verified by manufacturer over a year ago
Two component, rapid curing, 100% solids, spray applied, hybrid polyurea waterproofing membrane.
Application
Ideal option for providing a rapid cure waterproof membrane to a variety of application areas, such as:
- Podiums
- Roof Tops
- Balconies
- Retaining Walls/ Basements (Positive Side Waterproofing)
- Cut & Cover Tunnels
- Planters
- Non Potable Water Tanks
Description
Is a 100% solids, spray-applied hybrid polyurea waterproofing membrane that allows for rapid curing and installation.
- Successfully tested to AS4654.1, ensuring compliance with the deemed to satisfy criteria of the National Construction Code for external waterproofing.
- Extremely fast curing for application in areas with imminent rainfall.
- Solvent free, low VOC.
- Monolithic application minimises the chance for water ingress after membrane application.
- 100% Solids helps ensure a high level of quality control during installation.
- 1:1 Mix Ratio for accurate mix ratio.
General information
Material | Hybrid-Polyurea waterproofing membrane. |
Uniclass | |
NATSPEC National Classification System | 0411 Waterproofing – External and Tanking |
SpeedSpec | 07500 Membrane Roofing and Plumbing 07130 Waterproofing and Tanking |
SpecPack | 07500 Membrane Roofing and Plumbing 07130 Waterproofing and Tanking 07510 Membrane Roofing and Screeds |
Product range |
Specification data - Polyurethane (PUR) waterproof coatings
Standard | To AS 4654.1.Guidance for specification option: In compliance with the NCC for external waterproofing in Australia. Check with manufacturer. |
Form | Two-component, 100% solids and spray applied. |
UV resistance | Not UV stable.Manufacturer guidanceBecomes yellow and brittle if exposed to sunlight for a prolonged period of time. As such, if exposed to UV, Check with the manufacturer for required UV stable top coating. |
Colour | Black.Manufacturer guidanceFor special colours available upon request. Check with the manufacturer. |
Curing time | Minimum 4 minutes and a maximum of 3 hours. Guidance for specification option: Primer must be applied if coating exceeds 3 hours curing window. Check with the manufacturer for recommended Primer. Manufacturer guidanceCure times are based upon standard ambient conditions of 23°C, 50% RH. Check with the manufacturer. |
VOC content | 0 g/L. Manufacturer guidanceCheck with the manufacturer VOC Data sheet. |
Sustainability data
Country of material origin | Australia |
Country of product manufacture | Australia |
Literature
TREMproof P85 VOC Certificate
TREMproof P85 TDS
Tremco Waterproofing Brochure
Similar products from Tremco
AlphaGuard BIO
TREMproof 201/60R
TREMproof 250GC
Vulkem 350/346
Vulkem 360NF/951NF
Vulkem NEM