QSS QuelStop Acrylic Sealant

Features and benefits:

• Used as a fundamental part of the QuelStop Fire Batt system
• Suitable for use around cables, cable bunches, cable trays, cable ladders and non-combustible pipes
• Suitable for use in flexible walls, rigid walls and floors
• Suitable for linear joints up to 50mm wide in concrete to concrete/steel/softwood
• Suitable for linear joints up to 20mm wide with gypsum board/steel headtrack
• Suitable for low movement joints and remains flexible – maximum movement capability is ≤7.5%
• Suitable for use around wooden fire door frames
• Shelf life: 18 months
• Available in 310ml cartridges or 600ml foil packs
• Manufactured in the UK
• Expected to last the lifetime of the building

Standards and approvals:

• Up to four hour fire rating (EI 240).
• Fire resistance testing to BS EN 1366-3 and BS EN 1366-4
• Classified to EN 13501-2
• CE Marked
• ETA: 17/ 0788 and ETA: 17/ 0789
• Acoustic tested to EN 10140 to 48 dB
• Air Permeability testing to EN 1026: 600–100 Pa 0.0/0.0 m³/h/m²
• VOC tested: ASTM D2369-10, LEED 2009-EQ041 SCAQMD

Packaging & Storage

QuelStop Intumescent Acrylic Sealant is supplied in disposable cartridges or foils, packaged in cardboard boxes and must be stored in ventilated, cool and dry conditions.

Recommended temperature ranges for storage and application are between +5 °C and +35 °C.

Health & Safety

QuelStop Intumescent Acrylic Sealant should be handled and applied wearing appropriate protective clothing, including gloves, dust mask, safety glasses, to guard against dust inhalation, eye and skin irritation.

Installation:

QuelStop Intumescent Acrylic Sealant is a fundamental part of the QuelStop Fire Batt System and should be applied to all cuts, joints and exposed edges of the batt and can also be used for sealing around services such as cable, cable bundles, trays, ladders and non-combustible pipes, either as part of a seal directly within the wall substrate or as part of a QuelStop Fire Batt Seal.

QuelStop Intumescent Acrylic Sealant can also be used as a linear joint seal in a range of applications between concrete and concrete, steel or softwood and also to a gypsum board headtrack and around wooden fi re door frames.

• All surfaces must be clean and free of any bond breaking contamination prior to application of the sealant.
• The sealant should not be applied if the ambient temperature is below 5°C or above 35°C, as the adhesion may be impaired.
• The sealant is fast curing, approximately 15 – 60 minute tack free time, depending on the temperature and humidity.
• In linear joint applications, mineral wool or PE backing rod, can be used as a backing material to ensure the correct depth of QuelStop CE Marked Intumescent Acrylic Sealant is applied in order to achieve the required performance.

For full details on application and installation, refer to the associated document "Installation Instructions"